Allow to apply different-sized countersinkings (length and angle) to each type of drilling.

• In/Out counter sinking: Allow to activate the counter sinking. A boolean parameter can be used to condition the counter sinking creation.

• Length: Value of the countersinking length.

• Pitch factor:

If the drilling primitive is a tapping hole, you can use a counter sinking length whose the value is function of the pitch and a factor defined by the user.

The formula value is as follow: Ø counter sinking = Ø hole + factor x pitch.

In this case, the value of the Length filed is not use.

• Allow to activate the use of a pitch factor for the counter sinking length. A boolean parameter can be used to condition the use of a pitch factor.

• Enter the pitch factor value.

• Angle : Value of the counter sinking angle (half angle of the cone).

• Color : You can add a color to the counter sinking. If a machining process with color setting is use too, TopSolid will use the color of the machining process.