Edit Set

This command allows you to define sets which will be referenced in the draft.

A set can be a document, part or assembly.

Creation stages / Use:

Select the popup command Edit Set... from a main view.

Source document:

Select the open document to use here.

The option "<non specified>" will create an empty set. The main views using this set will therefore be empty but it will then be possible to insert another set by editing the view set (right button on the view).

Representation:

If the source document contains different representations, select the one to use.

Main Configuration:

If the document contains different configurations, select the one to use.

Auxiliary Configurations:

If the document contains different configurations, this command allows you to select the configurations displayed in various strokes (for example, minimum, maximum, overall, ....)

Information from this set that will be used for informing the cartridge.

If the views created from this set are deleted, the main set is emptied and as a result, so is the title block information:

If there was another set in the document, it would automatically rise in the main set and the title block's information would be automatically modified.
Otherwise, when a new item is projected, the main set will automatically retrieve this source and the title block information will automatically be modified.
The sets following the main set will be named "Set 1", "Set 2", ...

If no document is open, you can still validate the dialog. The main views using this set will therefore be empty but it will then be possible to insert another set by editing the view set.

Available Options:

Filter: This option allows you to use visualization filters. For example, a part may be visible or not using these filters.

Source document: This option is available only if a filter by entities has been created in the source document. By default upon creation of the view, the entities are visible, this option must be checked to hide them.
Filter Documents: Open or locked filter documents will be listed. You must check the filter documents to use.

Trim volume: This option allows to use a trim volume to show only a part of a projected set.

See help of the trim volume command for explanations about this option.

Advanced Options:

Project texts: This option allows you to get the texts from a Unfolding (Bend notes) or Drawing document.
Facetting: The faceted shapes resulting from an STL or IFC import are managed in exact projection mode. You can modify the quality of the local cross sections and limited views by adjusting the faceting tolerance.

Modifications / Additional information:

You can edit an existing set via the entity tree.