Contour

The Contour command automatically allows a succession of lines and arcs to be created with coincidence relations.

Creation Stages:

Click the icon or select the 2D sketch > Contour... form the drop-down menu. In a Draft document, select the Sketch > Contour... form the drop-down menu.

Chose a creation mode of the segment, the Line mode is chosen by default.

	Line	Creation of a line by two points. This mode contains 4 sub-modes allowing to move the cursor freely, horizontally, vertically or both. : The cursor can move freely in the sketch plane : The cursor can move horizontally or vertically. : The cursor can move horizontally only. : The cursor can move vertically only.
	Tangent arc	Creation of an arc tangent to the last element of the contour.
	Perpendicular arc	Creation of an arc perpendicular to the last element of the contour.
	Arc	Creation of a circle arc by three points.
	Passing	Creating a contour by passing over the existing geometries (edges of a shape, sketch, etc.).

Enter passing points coordinates of the segment or click points in the graphic area.

A Coordinates relative to button on end point allows to give coordinates relative to sketch origin or relative to last vertex.

	If you wish to create a closed contour, finish your contour by clicking the start point of the contour again or click the last segment of the contour. Otherwise, click the icon or press the Esc key to exit the command and create an open contour.
	The selected creation mode is used one time, after it switches to Line mode except if the Lock option is checked, in this case the Interactive mode is not useful.

You can use the "A" key to switch from a line to an arc and vice versa. It allows to quickly create an obround.

Available Options:

The Lock mode allows to lock the interactive mode to stay permuted. For example, if you move the cursor to the last segment of a line in progress, TopSolid automatically switches to tangent arc. When the arc is done, it switches again to line. By checking this mode before position the arc, it will stay active and after position it another tangent arc is proposed

Interactive mode allows to switch between different Line mode, Tangent arc and Perpendicular arc by moving cursor on the last edge of under construction contour.

By default, in the circle, tangent circle or perpendicular circle mode, the circle arc is created in the trigonometric direction (counter-clockwise), check the Additional arc option to change to clockwise.

Additional Information / Modifications:

When a contour vertex is selected again, the construction mode is automatically enabled.