Dimensional Constraint
Dimensional Constraint
This command creates a dimensional constraint in a Wizard document. Thanks to this constraint, it will be possible, for example, to select the length of a screw based on the thickness of the different parts to be screwed. It will also be possible to ask a question which will appear in the dialog when this assistant is used.
Creation stages / Use:
Click the Dimensional constraint icon or select the Tools > Dimensional constraint... command from the drop-down menu.
Select the parameter to constrain in the drop down list. (It comes from a parameter published from the function of the associated part).
Select the type of constraint.
Parameter: can only recover one parameter or value in limit value.
Thickness: Calculation of the thickness of an item in relation to an axis. Can indicate a direction and a limit value.
Distance: Calculation of the distance in relation to a frame.
Select the geometry if Thickness or Distance have been selected:
Frame: when Distance has been selected in the type of constraint, select the reference frame. For example, the frame under screw head for the calculation of the length of the screw.
Axis: when Thickness has been selected in the type of constraint, select the reference axis.
Check or uncheck Response provided by another constraint. If checked, select the constraint in the drop down list. In this case, the result of the calculation of the constraint of this list is used, which must be the same type as the one to be calculated. If unchecked, go to stage 5.
Complete the question to ask. This question will be displayed in the dialog box when the assistant is used. For example to find the length of the screw, the question could be "Select the last part to fasten"
Select the operators of the values. For Parameter and thickness constraint types, a single operator should be entered. For the Distance constraint type, 2 operators are to be entered. For example, the parameter must be greater than or equal to ( >= ) the minimum value and less than ( < ) the maximum value. In this case, the value of the parameter will be between these two values. These operators indicate the distance between the reference item and the last plate and the distance of the reference with the exit of the last plate.
Select the type of optimization between none, equal, maximum, medium, minimum. For example, in the case of the length of the screw, the PDM proposes the screw this the smallest length regarding the conditions while its optimization type is minimum.
|
|
|
