Automatic relations
|
|
Automatic relations |
This mode allows the automatic creation of relations between the sketch entities to be enabled or disabled.
Use:
Click the icon or select the 2D sketch or 3D sketch > Modes > Automatic relations command from the drop-down menu. In a draft document, use the Sketch > Modes > Automatic relations command.
When this mode is enabled, the relations (alignment, horizontal, vertical, tangency, coincidence, etc..) are created automatically.
When this mode is disabled, the relations are not created.
|
|
Activation of this mode may over-constrain the sketch. In this case, the relations of no use must be deleted manually. |
Additional information:
This mode is enabled when the icon is pressed (the background remains colored).
