|
Displacement result |
This command allows you to graphically view the displacements distribution of the part.
Creation stages / Use:
Select Results > Displacements result... from the drop-down menu.
Select the displacement that you wish to view.
Validate
A new result is generated each time this command is launched. Each result visualization created by this command can be found in the "Results" folder in the entity tree. |
Available Options:
Combination:
When the analysis preparation document contains at least one combination, the analysis result will use only this one to solve the constraints.
Options available in this area are explained here .
Combination Max:
This option allows you to display the result of the worst combination (combination with the highest stresses).
Display Maximum:
A label is added to the graphics area pointing to the node where the constraint is maximum.
The value is displayed in the label.
Additional information:
You can therefore update the result that you wish to view on the part. To do this, use the popup command "Make current" that you can access by right-clicking on the desired result in the "Results" folder of the entity tree.