Safety Margin

This command activates a creation mode in the cooling sketch with:

Creation stages / Use:

Click the icon, available only in sketch editing.

Both Margin and Collision Control modes work together or not:

It is possible to display the safety margin without collisions control.
It is possible to control the collisions of the circuit without displaying the safety margin (but taking in account its value).
Finally, the collisions control can be applied on the circuit with displaying the margin.

Available options:

Safety Margin: This option defines the margin of safety to be displayed around the cooling drillings. This margin is defined at the radius. .


Edition of the cooling sketch without safety margin.	Edition of the cooling sketch with safety margin.	The Margin is the delta to the diameter of the cooling circuit.

Collisions with parts: Tests the collisions with the parts non operated by the circuit.
Collisions with holes : Tests the collisions with the different holes present in the operated parts.
Intersections: If two shapes collide, the common part is shown in red if the option is checked. If the option is unchecked, the collisions are marked by a red cross.
Dynamic: This mode makes it possible to calculate the collision control dynamically, during segment dragging of the circuit for example.

Edition of the cooling sketch with safety margin and collisions control.

Modifications / Additional information:

This command is only available when editing the cooling sketch. The margin will only be visible when editing the circuit.

Activations of the safety margin and collisions control, are not preserved at the exit of the sketch.
The last selected settings are kept.