NC Operations Manager

It is possible to show automatically the operation tool path after its creation. The eyes will be opened in the operations manager.

The option "Show insertion operation" allows to display an insertion cursor in the opertaions manager.

It is symbolized by a red arrow.The user can move this arrow in the operations manager.

All new operation will be automatically inserted below this insertion cursor.

An icon appears in the machining document tab in order to show that this cursor has been manually moved and therefore it is no longer at the end of the operations manager. Just click on this icon to move the insertion cursor at the end of the operations manager.

On the left part of the opertations manager window it is possible to display further informations.

If these informations are selected, a check mark will appear in the respective columns to indicate if the verification, the clashes research, the adding of technological points or an event occured in the operation.

If an operation is executed, the check marks relative to the verification and clashes research are automatically deleted.

In the example below:

The facing operation N°1 has been verified, no collision was detected.

The side milling operation N°2 has not been verified and technological points have been added on the operations.

The drilling operation N°3 has been verified, a collision was detected.

The following icon allows to manually modify the colums to display in the operations manager.Once the document is saved, the columns display is kept for this document.